Foundry Project Page 22

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click Here to Re-Display the Main Project Page

Going...

Gone! Here you can see about a 1/3 full crucible. I need to feed the rest of my scrap into the crucible, but the scrap is too large so I'm going to have to remove my lid to do it. This will loose a TON of heat, but I can't get it in there any other way. Next time I will remember to put all the larger stuff in first. Saving the smaller stuff for the hole in the top of my lid. This will help a LOT with melt times.

Here I show the lid removed and that baby is glowing nicely.

Feeding some larger stock that won't fit in through the hole in the lid.