Welcome to OUPower.com
"Over Unity Power" Research

Nerd Weed Project Page 3

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from Nerd_Weed

Click Here to Re-Display the Main Project Page

Proceed to another page of the Nerd_Weed Project: [<<<   <      >   >>>]

Ok, after a long project im back... after reading about a recent debunk of the Joe Cell when the Validation was asked in the Clean Energy Seminary i decided that tubes are evil,expensive and hard to work with.
I already had 5 10x10cm plates with 1 hole in the corner and tryed some electrolysis with neutrals an paraleles plates and since this cuts(plates) are the most used in the cells i'll buy a 2mx1m 304 ss plate and ask for a friend to cut it for free in his work(great company) 40 6"x6" with this plug for a bolt for the electrical connection and a hole in the middle so i can pass a nylon bolt and sepate them with 3mm nuts... the sizes are not fixed since im going to find whats avaliable in the shop.
with this design i use +-+-+-+- with the positive plug in the left as shown in the draw and the negative plug in the right... if i want only a few connected, like with neutrals, i can put the plug down and done.

Proceed to another page of the Nerd_Weed Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from Nerd_Weed

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!