Welcome to OUPower.com
"Over Unity Power" Research

Nerd Weed Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from Nerd_Weed

Click Here to Re-Display the Main Project Page

Proceed to another page of the Nerd_Weed Project: [<<<   <      >   >>>]

Ok so this is my lab... not a good one i know... but since i lost my house now i have to face a small apartment life... and sure it isnt so clean as it should be...
Anyway.. Im here to try every single project i have seen and liked. Why ? becouse its fun, and it can get intersting when you start to learn with your projects and make an improvement that could... you know... well.. its me just thinking big... But after all i want to buil some open source products like a boiler, a camp oven and stuff like that.

Well, i was really intersted in the joecell idea... and it was cheaper them buying 8 5x5" plates
It was hard to find a place in Rio de Janeiro that could sell stainless steel tubes smaller then 6meters long. When i founded the guys cutted 4" long tubes of each 1", 3/4", 1/2" and it costed me R$12, R$8, R$5(US$5, US$3, US$2.50)
how much does it cost in your country ? maybe you can spoonser me... its cheaper :P lol

it was so hard to isolate it... had to cut a pressure cooking rubber so it could fit the 1,5mm space

For now i'll use a 12v 1A source... in a week i'll start to build a adjustable power suply that goes 0-30v and 0.002A-3A.
Well... this is not the actual 12v adapter that im using since this one is broken and it is 9v :P but the cam batery ran out before i could get a shot of the real one

This is my cell assembled...
some one told me that it had too much rubber blocking the gas output but i wasnt a problem at all.
All isolated with pressure cooking rubber

Proceed to another page of the Nerd_Weed Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from Nerd_Weed

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!