by waterboy » Tue May 20, 2008 10:25 am
For right now, my faucet is producing the vacuum but as I stated, your engine will produce a minimum of 13 inches and another 20 inches from a small vacuum pump attached to the engine will be far less energy than the hydrogen it will produce.
Hopefully an A/C pump which can clutch on and off will work.
But for right now, for demonstration and educational purposes, imagine every little tiny bubble your cell produces pops out of the water 20 times the size it is presently. Imagine using a fraction of the power you are using now. That is what I described will do.
I for now my gas is going down he drain so to speak but all that water vapor and gas goes through that plasma tube from there and I doubt what is coming out the other end is steam (it does not produce visible steam)
If you put a piezo device in the water bath it would crack since the water would instantly fracture and without water against piezo it will crack usually unless very low power is applied.
All of these things, vacuum, plasma, piezo are low energy consumption devices.
When you look at the Meyer first run video, a 13 PSI vacuum with 5 volt and 2 amps is exactly what you would expect to see. Bottom line, that is the secret.
The pressure on a spacecraft hull is 14PSI. That is a full vacuum as I recall.