First off I am SO pleased to be apart of this site and the progress so many of you have made.
So i have been looking at the forums for a bit, I actually have made a plate syle cell and was wandering about a few things........Oh and btw you all have done some way cool work.
So i have a plate cell, with just the light switch plates, and i am using brute force electrolysis (just current from car battery).
I have seen the circut board controllers on here. Here's where my questions come in.
1. Where can i buy the pars to make the frequency controller used on ravis cell?
2. Is a plate design or should I invest in a cell like the ravi/meyers cell?
2-a. And if so where can i buy the tubes.
I apologize for the simple newb questions but i would really like to add to the knowledge here on the site. I know electronics ok, but i know cars VERY well. And would just like a decent cell to to experiment on, and to run in my car as well.
I have tried the smacks booster and was not impressed, can you help? thanks in advance!