by Hybrid » Wed Jun 25, 2008 10:48 am
Hi Glenn. I have drawn up a different cell arangement that would produce
a larger H vol compared to the amount of O. Even the Stan cell uses 2
sizes of tubes. Of course the bigger neg dia will make more H bubbles.
To me a 50/50 blend of H + O is mild, especialy without atmos to match.
I know this forum has proven that a series cell uses less power to run it.
But at the expence of more power to run a parrallel cell, I'd like the ratio
of H to be higher than the O, plus allow atmos air to be drawn through too.
Glenn what do you think of 20 neg plates (bridged with s/s rods outside)
meaning with no holes, & 10 pos plates bridged, both in the same cell ?
So far it would be higher in H than O. Peak the roof better for extraction.
An oxy valve could regulate the atmos air being sucked into the 2nd
bubbler for idle & lowish vac. A 2nd atmos tube that allows more in when
an adjustable hobbs pres/elec switch opens a smallish size solenoid for
high vac/revs. To me this would be more explosive & sequential in flow.
Glenn throw in your 20c for pros vs cons. Cheers !
--Anthony