Welcome to OUPower.com
"Over Unity Power" Research

Hydrogen Fuel Project Page 2

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click Here to Re-Display the Main Project Page

Proceed to another page of the Hydrogen_Fuel Project: [<<<   <      >   >>>]

Nice PIC from the side of the new reactors. The water level is FAR above the plates so there is never any exposed metal in this new design.

Just a few more angles for you.

Yet another one so that you can be sure to see what I've done.

I used some older electrolyte so the discoloration is from that; not from the new setup.

Here's the lid of one of the Walmart Cereal containers. It's very hard to see but I put Goop Glue all around the inside lid. I did this a very specific way to help ensure a tight seal. I opened the lid first the whole way. I then started squeezing the glue container while nipping off little globs of glue all around the inside rim. This made a bunch of little joined blobs all around the inside edge of the lid.

I then closed the lid which further smooshed and distributed the glue evenly along the entire lid. This gave a very good seal on the lid and I am hopeful that it will withstand quite a bit of pressure before popping opened. In fact I hope that this seal never pops open really.

Proceed to another page of the Hydrogen_Fuel Project: [<<<   <      >   >>>]

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!