Sealed Cell Project Page 8

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 17, 2010 10:33am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

I found that using the table to help bend these left the corner a crisp 90 bend, rather than a loose arched bend when using your hand.

Here is a mockup to make sure the cut is right. I made sure that the fitting would sit centered on the center threaded rod, which is dead center for the plates.

Here I bent the second peice and now I'm finding where to cut. Ignore the small pieces on the tubing, these are assembled wrong.

Here is the cutter. It was a small pain trying to get the cutter to cut straight instead of walking to one side or the other.