Welcome to OUPower.com
"Over Unity Power" Research

Sealed Cell Project Page 6

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 17, 2010 10:33am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

Proceed to another page of the Sealed Cell Project: [<<<   <      >   >>>]

Here is the start of the assemby. You see the spacer block with one of the gaskets on top. The plate assembly with be equally spaced in the center of the compression frame, with 1/4 on each side.

Here you see the gasket on the very bottom.

This is with all the plates assembled, starting with and ending with a negative plate, and with the last spacer block on top.

Here is with the compression frame's back plate installed.

Nut's and washers installed and tightened. The washers that you see lifted because of other washers are not tight, just snug. Once I find and eliminate the leaks from this cell I will then state what the torque is to get leak free.

Proceed to another page of the Sealed Cell Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 17, 2010 10:33am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!