Electrolysis Project Page 40

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from drewsky

Click Here to Re-Display the Main Project Page

Here we have the fully assembled cell. I have not put the barb into the top yet, that comes next. At this point the cell should be airtight.

Here we have a good front view. Notice that the nut on the right side of the plates is welded a bit higher than the left. This is done so that things hang as straight as possible in the cell.

Here you can see that everything is suspended just off of the bottom about 1/4 of an inch. This is done to allow for proper circulation below the cell as it pulls water up through itself.

Woohoo... adding the distilled water and lye.