Electrolysis Project Page 39

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:04am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from drewsky

Click Here to Re-Display the Main Project Page

Here is a view of the cell from the top down. I have not yet tightened the nuts onto the bolts but I wanted to give you a good view of how it is all assembled.

Another angle for you so there is no question as to what I have done.

The bolts are tightened into the cell plates from the outside. Once they are tight the inner nuts are then tightened up against the washers. There is 1 O-Ring on the outside and on the inside I have 3 nylon washers then the nut. That's it :)

Here you can see the O-ring from the outside.