Welcome to OUPower.com
"Over Unity Power" Research

Electrolyser v4 - Abandoned container Project Page 3

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:37am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from nakros

Click Here to Re-Display the Main Project Page
Project Description:
Electrolyser v4.  

-In this version, my main goal was to minimize the amount of standing hydroxy in the system.
-I changed this version to submerged, instead of series.  Series cell electrolysers are quite a pain in the butt.
-Everything in this version is quite cheap ($20 in shim stock, $30 in hardware, $4 in containers, so far).
-My ultimate goal is to create many of these units in series, off a 24v power supply, and to create enough gas for welding.

Updates:
10/10/05 - Updated title of the project.  Abandoned because of difficulties sealing the container.

Proceed to another page of the Electrolyser v4 - Abandoned container Project: [<<<   <      >   >>>]

Then take a drill bit that has an O.D. that is smaller than the inside of the threads of the threaded nylon ro.d

Picture of the gas nipple on the container.

Picture inside of the nipple.  Yeah, so I wasn't directly in the center.  It works -- thats all that matters.

The setup all hooked up for its test.  The test ended in failure.  I have a leak somewhere.  I really hope it isn't the ziplock containers.

I've grown rather attached to them, and fear that I'd miss the little buggers.

A picture of the action anyhow.  Seems like fair gas production -- I wasn't overly impressed, really.  I think it has alot to do with my uneven spacing of the strips.  After I add the weatherstripping between the ends of the plates, I think things'll turn out much better.

Proceed to another page of the Electrolyser v4 - Abandoned container Project: [<<<   <      >   >>>]

Click here to continue Drilling into Projects from nakros

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:37am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!