Sealed Cell Project Page 3

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 17, 2010 10:33am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

Before and after of the soldering process. I think these plates were soldered while I was trying to find out which flux would work so I'm not sure which one these used

Flipped

This is the "new" compression frame. This is how I had designed it when I had it in my mind and on AutoCAD. It is using 12" 1/2-13 threaded rod and it very close tolerance, so close that if the back plate gets skewed more than 1/8in it binds and won't move.

This is the entire assembly sprawled out so I can show each item.