Sealed Cell Project Page 11

Welcome to OUPower.com
"Over Unity Power" Research

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 17, 2010 10:33am v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from mos68x

Click Here to Re-Display the Main Project Page

This is after a couple hours and the water was very hot.

You can't read the numbers on the scale, but it says 40g. I didn't want to add this much since I knew that it would over amp the cell.

This is only 10g of NaOH. I'm still not really comfortable adding this much but I'll try it anyways since it will be less than 0.25%.

Here is after I added only 1g, yes I did say 1 (single) gram of NaOH. The cell start overamping and destroyed my jumper cables on the car.