Hardcore Information

[mos68x]

[mos68x]

[AlaskaStar]

[mos68x]

[AlaskaStar]

The shaft presses out of BOTH sides of the Rotor hands.

N40 will work, it just won't be as strong.

AlaskaStar

[mos68x]

Thanks, I'll take it to work this morning and see if I can get it apart. If not then I'll send it up there for you to help me get this thing apart.

Is pressing the shaft into place as hard as it is to press it out?

[mos68x]

Well I got my answer today like I thought I would. We can't do it with the equipment that we have, we only have a 10ton press and I'm sure that won't be enough to split it, or at least not with damaging the shaft in the process.

I will be shipping this shaft to you so you can pull this thing apart for me. Can I put it back together with the 10ton press? Or will I have to have a larger one to do that too?

[cwaugs]

[cwaugs]

[AlaskaStar]

[cwaugs]

[AlaskaStar]

[haroldcr]

FINALLY got my Magnets installed into the 105Amp Delco. Had to machine a tiny bit out of the inside of the claws, so the magnets bottomed out.

Put the thing together, and spun it up on my Lathe. at 1750 RPM's, I read 14.4 volts no load, phase to phase ??? Doesn't seem like it's worth the effort.

I thought these things would spin up to over 100 volts or more. ???

I realize that 1750 is just getting started, but, maybe I'm missing something ???

I used 3" N45's, 2 @ ½". Clears the shaft by a tad over ¼" all around ???

Doing more research, I read that using a SS shaft would increase voltage.

Is this pretty much what I get to work with, or, what did I screw up ???

[mos68x]

[haroldcr]