[quote="Go Hydro"]Waterboy, That’s professionally designed and fabricated to the fit, finish, and tolerance seen in my former career. It is some very nice machine work. Rotary table on vertical mill to index the holes in the delrin?
If I were tasked to create the assembly instructions for this cell, my biggest concern would be proper contact to assure continuity between the tubes and the “buss disksâ€
Secret to Herman Anderson's water fuel system...
by hydroz » Wed Jun 04, 2008 12:47 am
To clarify a small point, if the gas is to be supplied to an aspirated manifold then it has to be supplied through a venturi considering the manifold vacuum itself is at maximum while idling and minimal at full acceleration.
- hydroz
- Posts: 1
- Joined: Tue Jun 03, 2008 9:59 am
Re: OK waterboy
by waterboy » Thu Jun 05, 2008 2:39 am
- waterboy
- Regular Poster
- Posts: 280
- Joined: Fri Nov 02, 2007 3:14 am
Re: OK waterboy
by waterboy » Thu Jun 05, 2008 2:41 am
- waterboy
- Regular Poster
- Posts: 280
- Joined: Fri Nov 02, 2007 3:14 am
by Looking In » Fri Jun 06, 2008 9:15 am
Rich (Looking In)
((((Is it really so difficult to tell a good action from a bad one? I think one usually knows right away or a moment afterward, in a flash of regret.)))) BOOM
((((Is it really so difficult to tell a good action from a bad one? I think one usually knows right away or a moment afterward, in a flash of regret.)))) BOOM
- Looking In
- Regular Poster
- Posts: 367
- Joined: Thu Dec 22, 2005 11:06 am
Return to Hydrogen Production via Electrolysis
Who is online
Users browsing this forum: No registered users and 49 guests