Ok I have spent heaps of money getting an acrylic box made up.It has 7 seperate cells with 2 plates 6inch * 3inch spaced 3mm apart. It is fed with battery voltage on each end.I can get it to pull about 3 amps max cold and it makes around .5 lpm and I don't seem to be able to get it to pull more amps no matter what mix of noah and water I use.It seems to get to a point where amps and production goes down by adding more caustic.If I short the two middle plates across making just 6 cells it seems to draw a lot harder.Battery voltage was at 13.65 volts.Each cell is totaly seperate apart from gas channel at the top and is filled with a small plug in each cell.All looks impressive but aint working that well.
Anyone have any suggestions?
Thanks,
Mos