Welcome to OUPower.com
"Over Unity Power" Research

Bob Boyce Total HOH Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:37am
v7.00

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to the new OUPower.com Blog!!

Click Here to go to our Discussion Boards ...Discuss all sorts of cool stuff!

Please consider donating to help support this website!

Click here to continue Drilling into Projects from glenn_aircooled

Click Here to Re-Display the Main Project Page

Project Description:
Bob Boyce Total HOH
After some research I am getting ready to Duplicate a car running on Hydrogen/ Oxygen by the Bob Boyce method.!

DANGER : THIS is an Extremely DANGEROUS experiment. DO NOT do this unless you have followed every
precaution mentioned on this WEBSITE.
Improper use of this may result in DEATH or worse, Government interference. BEWARE .


Am still gathering equipment & ideas but at this stage it will be:
1> 66 plates of 316 stainless sheet. 0.7mm thick . 150mm x 150mm .
2> the box will only be about 330mm long with slotted sides and bottom.
3> the RESONANCE driving system will be a the HEX CONTROLLER that Bob designed - just not sure if I can manage the programming side.

4> I need to see the Double Bubbler mentioned somewhere on this forum - and may do similar.
5> Over pressure cut off on box.
6> Feed back system ( will be worked out ) to reduce voltage peak during resonance and hopefully adjust phase of harmonics to controll output as well.
7> will use an LPG gas converter throttle body but will need to find one that can be adjusted to
lower GAS pressure.
-
So I will need to test this concept on bench first then I will put inside PVC box in my car
and run it completely on Hydrogen and Oxygen from breaking up water.

Artists impression.... of the Bob reactor. Plastic filter to settle froth above plates.
Two Gas outlet pipes. Over pressure switch not shown. Water in feeds spray bar with outlets aimed at each cell. Two bolts connect to end plates only. One end is 120 V from diodes and other end is common from transformer.

Click here to continue Drilling into Projects from glenn_aircooled

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: September 25, 2006 10:37am
v7.00

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to the new OUPower.com Blog!!

Click Here to go to our Discussion Boards ...Discuss all sorts of cool stuff!

Please consider donating to help support this website!