Powering up Project Page 1

Welcome to OUPower.com
"Over Unity Power" Research

Powering up Project Page 1

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 15, 2007 11:17pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!

Click here to continue Drilling into Projects from Beshires1

Click Here to Re-Display the Main Project Page

This is a transformer from a microwave, I've removed the high voltage secondary windings, the filament winding, and the magnetic shunts.

This shows the history of this transformer. I really couldn't find out anything about how much voltage the secondary was puttin out.

This shows the secondary windows. Do not damage the lacquer laminated, plates when removing the secondary windings.I used a wood chisel to cut thru the windings. Then Knocked them out with a punch.

Ive relined the secondary windows with manila paper used super glue to hold paper in place. I,m going to try to rewind using 12 gauge multi-strand automotive plastic insulated wire. If I use single strand lacquered wire, I would cut pieces of 1/4 inch wood to space the secondary off the primary.

After winding a short piece if wire thru the secoundary window and counting the number of turns, I took a voltage reading. I found that it was pretty much one volt = one wrap. I want to build a 30 volt variable power supply. So here I have wound 32 wraps of 12 gauge multi-strand insulated wire on to the transformer.

Click here to continue Drilling into Projects from Beshires1

Click Here to Re-Display the Main Project Page

This Website is Created and Maintained by chris--at--OUPower--dot--com (Fix the address for it to work!)
This Project was last updated on: April 15, 2007 11:17pm v7.01

WARNING! Many, if not all of the projects described within these pages, contain dangerous and potentially fatal consequences if you do not exercise proper precautions and follow standard safety procedures. The owner of this site takes no responsibility for injury sustained by anyone attempting to duplicate or utilize any of the information on this site. The information here is strictly for Educational Purposes! -USE AT YOUR OWN RISK!

Click Here to go to my YouTube Channel!!

Click Here to go to our NEW Facebook Discussion Group! This is replacing the old Discussion Board!

Click Here to go to our ARCHIVED Discussion Boards.

Please consider donating to help support this website!